Steel and FRP plates are installed on the fixed and movable platens to insulate heat generation from the thermoset mold.
Special design that allows the gases inside of the mold to be released in two different stages.
Core and cavity mold temperatures are digital and are set individually.
SPECIAL SCREW BARREL DESIGN FOR THERMOSET MOLDING
Barrel sleeve is nitrified, and the screw is thermally sprayed to strengthen wear resistance and lifespan.
One-piece rod, less L/D ratio, and compression-free screw design make melt flow smoothly.
A linear transducer calculates the injection and plasticizing strokes and displays the correct and precise position.
The single-carriage cylinder at the rear side provides easy access to disassemble the barrel or nozzle and to save space on the purging area.
THREE-STAGES HEATING COMPONENT FOR KEEPING THERMOSETS UNDER A PERFECT PLASTISIZING CONDITION
A specific three-stages heating component (oil heater, electric heater, and cooling loop) used to maintain a stable barrel temperature and to ensure a good melt status of the thermoset material inside of the barrel.
The oil heater commissioning at the front of the barrel sleeve reaches an optimum temperature range to improve the repeatability of the quality of the article.